New Dodge Viii 3/4 Axle Preferences
the third fellow member has a casting, in addition to the 741 gets a lower rating because it has a 1.375 bring upwards pinon bearing
the 742 has 1 3/4
the 489 has 1 7/8
Since all Mopar eight 3/4 purpose the same diameter pinion U articulation flange hole (either coarse or fine spline.) The weakest link if in that location is i is the same location for all three.
But, in that location isn't much of a weak spot, the hemi was using the eight 3/4 so, that's pretty damn good.
http://www.jalopyjournal.com/forum/threads/dodge-8-3-4-strenth.458086/
the 742 has 1 3/4
the 489 has 1 7/8
Since all Mopar eight 3/4 purpose the same diameter pinion U articulation flange hole (either coarse or fine spline.) The weakest link if in that location is i is the same location for all three.
Baca Juga
- New Visual Identification Divergence Comparing Betwixt 452 Together With 906 Heads Then You Lot Don't Bring To Popular The Valve Encompass Off To Meet The Casting Numbers
- New In All Likelihood The Best Collection Of Musculus Cars As Well As Spare Parts Nosotros Are Going To Request Heed Of, The Don Fezell Collection
- New Visual Identification Divergence Comparing Betwixt 452 Together With 906 Heads Then You Lot Don't Bring To Popular The Valve Encompass Off To Meet The Casting Numbers
But, in that location isn't much of a weak spot, the hemi was using the eight 3/4 so, that's pretty damn good.
http://www.jalopyjournal.com/forum/threads/dodge-8-3-4-strenth.458086/
